ELECTRONIC CIGARETTE STARTER KIT: USER GUIDE

photo6

Though using an electronic cigarette is fairly simple, problems arise when new users aren’t shown how to use them properly. Electronic cigarettes are very delicate, so when using the device for the first time, ensure that you do not force any components. 95 percent of damages arise from over-tightened components, especially batteries being forced onto chargers.

The first step is to open your electronic cigarette kit and inspect the contents, as damages can occur during transit.  Make sure all the components are in the kit, including any extra things you may have ordered.

The second step is to unscrew the black mouthpiece, remove the child safety cap on your e-liquid and pour it at an angle into your glass tank. Pouring at an angle ensures the e-liquid flows around the outside of the glass tank and misses the top rubber section. There is a fill level marked on the side of the glass tank, so make sure you don’t overfill. Screw the black mouthpiece onto the tank to ensure the e-liquid is sealed; this is the only component that does need to be a little tight to seal in the liquid.

The third step is to charge your battery. Once this is done, and your tank is full of e-liquid, gently screw together your battery and tank. Always keep the two sections a little loose. DO NOT SCREW TIGHT, as this can cause extensive damage.

The next step is to unlock your device by rapidly pressing the button on your battery. The light will flash 3 times to indicate that it’s unlocked.

Finally, press the button while you inhale and depress when you have finished inhaling. The device will prevent you from overheating the electronic cigarette and will only stay on for 5 seconds when inhaling.

The battery will last around 3 days between charges. When ready to charge, gently screw onto your charger and either plug into the wall charger or into your USB socket on your PC. Do not over-screw the battery onto the charge. This will break the components. Just screw on until the battery flashes and glows. The charging process will take around 6-8 hours.

 

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *